| Home  Blogs Help Search Login Register  
« previous next »
Pages: [1] Print
Author Topic: valve timing murena S  (Read 2870 times)
carrera
Newbie
*
Posts: 5


« on: February 11, 2007, 12:55:55 pm »

I am having difficulty in obtaining the correct valve timing on my 'S' I have been told Inlet begins to open 27 degrees before TDC but I am always half a tooth out. I have had uneven running with bangs from the exhaust and must get it sorted. Is the timing done with zero valve clearance, which is the correct way or do you set the tappets at 0.2mm?
Logged
Anders Dinsen
Administrator
YaBB God
*****
Posts: 2822



WWW
« Reply #1 on: February 12, 2007, 03:44:02 pm »

Hi Carrera

I'll have to check the workshop manual... but I think there would be an alignment mark in the cam shaft?

As far as I know, banging in the exhaust would normally be because carburation is wrong... too rich specifically, do you know if the carbs are okay?

- Anders
Logged

'82 Murena 2.2 prep 142
'01 Grand Espace 24v
'08 Smart Fortwo 0,8 cdi
michaltalbot
YaBB God
*****
Posts: 566



« Reply #2 on: February 12, 2007, 04:44:53 pm »

Hello,
Anders is right. On the flywheel there is mark which have to be at zero position and also on the upper timing wheel there is a mark which have to be on the top. Also when You have bad pre-ignition it could make banging...
Often the worst looking problems have the most trivial reasons  Wink
« Last Edit: February 12, 2007, 09:21:03 pm by Lennart Sorth » Logged

Pages: [1] Print 
« previous next »
Jump to: