Hello!
I need to make som reconstructive surgery (no surprise) on the the mounting
points for the lower front suspension beam - that is the beam which holds the
lower A-arms. The mounting points however are totally rotted and to the degree
that I their original possition is very hard to guess. And it is not only the rust
but as the detoriated points have also lost their strength they have also been
deformed by several cm. In fact the whole beam just dropped to the ground
when I unbolted the rest of the suspension
Now, I'm wondering if somone with an intact Bag (do they exist?
) can help me
to determine the correct possition of the beam so I can weld up new points.
I have attached a picture which indicates two meassures that I'm intressted
in:
A. This is the up-down possition. I guess that the meassure A from the upper
beam mounting plane to the lower beam mounting plane should be a good
and easy one.
B. This is the front-back possition of the beam. This possition I'm not sure
how to easilly meassure. I idicated a line B on the beam that is easy to get to,
but I'm not sure to which other point to make a meassure. Any ideas
or usefull meassures are wellcome.
Thanks,
Anders Karlsson