|
|
|
|
|
Oetker
YaBB God
Posts: 1097
|
|
« Reply #5 on: October 15, 2016, 07:56:46 pm » |
|
Hammer and chisel and a bit of heating. Easy to loosen. There is a lot of wrong info about the lower balljoints. Sellers provide wrong info saying Rancho Simca 1100 bagheera and Murena have the same type balljoints. Only Murena and Solara share the same ball-joints the others have a smaller type. Be shure to have the right type. Herman
|
|
|
Logged
|
I feel like Jonah, only my fish looks different. Murena 2.2 Red 1982. Murena 1.6 black on places.
|
|
|
Matra_Hans
YaBB God
Posts: 659
Owner of Bagheera, Rancho, Murena & Espace
|
|
« Reply #6 on: October 15, 2016, 08:12:58 pm » |
|
Lower ball joints: I have not tried to change them, but it looks to be difficult, however I have a set in the store” just in case”. However I have changed the upper ball joints a couple of times. You will need a special tool: In Danish it is called “Styrekugle aftrækker”. And you can get it from Biltema, Harald Nyborg, T-Hansen, Heyer etc. Last time a changed an upper ball joint the special tool was not sufficient to get the ball off the upper arm In the first attempt I broke the tool !! I got a new tool, heat the arm a lot and finally use a new big hammer. Hans
|
|
|
Logged
|
|
|
|
|
|
Oetker
YaBB God
Posts: 1097
|
|
« Reply #9 on: October 16, 2016, 11:16:42 am » |
|
Yep thats the righ one 48mm and 14mm QSJ815(S) If you buy TC93 from Delphi you have the wrong one. Delphi right number is TC-200 but I never saw one. Always verify with the seller if they have the right thread. If no answer, don't buy. Some fabrics copied specs from Delphi catalog so there are several wrong items around. Herman
|
|
« Last Edit: October 16, 2016, 11:55:07 am by Oetker »
|
Logged
|
I feel like Jonah, only my fish looks different. Murena 2.2 Red 1982. Murena 1.6 black on places.
|
|
|
|
|
|
|
|