Title: inlet flange CAD drawings (2.2)
Post by: krede on June 26, 2011, 08:05:32 am
For having a flange laser cut for a new inlet manifold. Are there any out there?.
Title: Re: inlet flange CAD drawings (2.2)
Post by: RazorbackNOR on June 27, 2011, 08:08:19 am
If you have the measures, I could make the drawing for you.
I don't have access that deep inside the engine to get them on my Murena.
I don't have access that deep inside the engine to get them on my Murena.
Title: Re: inlet flange CAD drawings (2.2)
Post by: krede on June 27, 2011, 08:40:52 am
Thats very kind of you, but don't bother. I have an inlet gasket that I will scan. I think it is possible to import this into autocad somehow :)
Title: Re: inlet flange CAD drawings (2.2)
Post by: RazorbackNOR on June 27, 2011, 09:43:21 am
Use Inventor instead, much easier to import and use, and you can make all parts in 3d easily and check that all fit together. I do use both programs on a daily basis.
Title: Re: inlet flange CAD drawings (2.2)
Post by: krede on June 27, 2011, 09:47:56 am
So... perhaps you could be perusaded to make me a drawing after all? :)
