|
Home
|
Blogs
|
Help
|
Search
|
Login
|
Register
|
MatraSport Forum
>
Each model
>
Espace
>
Espace III, front wheel bearing
« previous
next »
Pages:
[
1
]
Print
Author
Topic: Espace III, front wheel bearing (Read 4456 times)
jack daniels
Sr. Member
Posts: 132
Espace III, front wheel bearing
«
on:
October 22, 2010, 09:42:01 am »
Hi folks,
Is it normal practice to apply loctite selbloc to the outside of the front bearing assembly before pressing it into place?
Do I need to apply loctite selbloc to the driveshaft splines when I refit it back into the hub?
According to the workshop manual all Espace JE driveshaft splines were "glued" with loctite selbloc at the factory.
I assume that the application of loctite is to preserve the surfaces and keep them from seizing together allowing easier disassembly. Normal grease on the outside of the bearing will probably just dry up and disappear after reassembly.
what is the normal practice?
Or has anyone found it difficult to push the driveshaft out of the hub, and press the bearing out because it was not preserved with Loctite?
Logged
Espace, Grand (magnifique, formidable, grandiose, considérable, noble, ample) III
2002 JE02 F4R DP0 2.0L 16v auto
colin4255
Sr. Member
Posts: 119
Re: Espace III, front wheel bearing
«
Reply #1 on:
October 29, 2010, 12:59:32 am »
I asked my garage about this. When they replace bearings they just push them in. As it takes about 7 tonnes pressure to push one out or in, they say its irrelevant whether or not they rust up to some limited degree. They are by the way, Renault Dealers. I have replaced one and they did another, not had an issue removing, and I didn't grease or lock the bearing in, just used a press to push it into the hub.
Logged
jack daniels
Sr. Member
Posts: 132
Re: Espace III, front wheel bearing
«
Reply #2 on:
October 30, 2010, 05:29:51 pm »
The new QH bearing came with only 1 retaining ring and the wrong size nut.
I used loctite on the outside of the bearing and the driveshaft splines.
1 of the old retaining rings was re-used so now it has 2, the same as it was from the factory
The old bearing felt OK actually so I hope I've replaced the correct side. Tomorrows test drive will reveal all.
Logged
Espace, Grand (magnifique, formidable, grandiose, considérable, noble, ample) III
2002 JE02 F4R DP0 2.0L 16v auto
Pages:
[
1
]
Print
« previous
next »
Jump to:
Please select a destination:
-----------------------------
General Matra related
-----------------------------
=> Announcements (moderated)
=> General Discussion
=> Marketplace
=> Lennart Sorth's Blog
=> Anders Dinsen's Weber Blog
=> Spyros's MatraSports Page
=> Henrik P's Blog
=> Nickel's Blog
=> Razorback's carb Blog
=> Murena nosecone
=> Oskar's Blog
=> E.space.3
=> Ib's Blog
=> WENs 2 Mk3 Espaces
-----------------------------
Each model
-----------------------------
=> Espace
=> Rancho
=> Murena
=> Bagheera
=> M530
=> Djet
=> Avantime
-----------------------------
Additional features
-----------------------------
=> Native languages
===> MatraSport Danish
===> MatraSport Français
===> MatraSport German
Loading...