For those of you not yet bored with my "doings", ....a question!
When does a solution become a bodge???
As you may remember I have been tying to fit electric windows to eow. The actuators being from a Renault 9 didn't fit in that the outer tube the flexible control arm slides through was too long making the mounting of the motor impossible.
I had already made an upper support and riveted this to the actuator to add additional support and the only way of positioning the motor was to cut a section of the outer tube off.
This enabled the motor to be positioned in the right place but when the window reached the top the tubes just pushed apart.
After thinking of how to permanently join the two ends for several weeks, I came upon the idea of using a 10mm "push fit" gas connector.
The electric window now works perfectly (courtesy of the new switches) am absolutely delighted.......on to the next side