Title: Changing the bearing on the Mac Person suspension.
Post by: 2cv on April 30, 2011, 08:34:40 am
I need to replace the bearing on the front suspension do I need to dismantle the unit or is it enough to unbolt the unit from the car to fit the bearing?
Would any of you have a exploded drawing of the unit?
Best regards
Lars
Would any of you have a exploded drawing of the unit?
Best regards
Lars
Title: Re: Changing the bearing on the Mac Person suspension.
Post by: jack daniels on April 30, 2011, 09:56:41 pm
the spring/ shockabsorber assy must come out and you'll need a spring compressor.
It's best to replace the top bush that's on the top of the spring at the same time.
SKF have a set with the 4 required parts which is pretty cheap.
SKF part number: VKDA 35620T about 100 euro.
( 2 assembly drawings are below, log in to view )
It's best to replace the top bush that's on the top of the spring at the same time.
SKF have a set with the 4 required parts which is pretty cheap.
SKF part number: VKDA 35620T about 100 euro.
( 2 assembly drawings are below, log in to view )
Title: Re: Changing the bearing on the Mac Person suspension.
Post by: 2cv on May 01, 2011, 11:13:12 am
Thanks Jack
Just what I need, I will order new sock absorber since everything has to be taken apart.
Lars
Just what I need, I will order new sock absorber since everything has to be taken apart.
Lars
