MatraSport Forum

Each model => Murena => Topic started by: Rayburn on August 31, 2015, 12:45:06 pm

Title: Driveshaft bearing carrier
Post by: Rayburn on August 31, 2015, 12:45:06 pm

Refurbishment of my 1.6 has progressed to the back of the car. I need to separate a bearing carrier from its driveshaft to replace the cv boots. I was expecting to see a circlip holding it on but this is what I have found (see attachment) Is there a trick to getting bearing carrier off the shaft?

Thanks

Title: Re: Driveshaft bearing carrier
Post by: Oetker on August 31, 2015, 01:09:37 pm

You don't have to seperate the axle for it if you use universal boots.
(http://a.imageshack.us/img830/5818/p1020595medium.jpg)
(http://a.imageshack.us/img837/924/p1020597medium.jpg)
(http://a.imageshack.us/img42/7780/p1020600medium.jpg)

You can also use a Cola bottle for it or a cone.
(http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090401_zps43e6810d.jpg)
(http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090423_zps53e36556.jpg)
(http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090427_zps5d800710.jpg)
(http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090429_zps17f7f959.jpg)
Last 4 pics Bart Maztra.

Make sure to find  the better quality boot.
The cheap Chinese sh*t don't last long.
Also put the boots before mounting in warm water to soften it.

Title: Re: Driveshaft bearing carrier
Post by: Rayburn on August 31, 2015, 02:19:11 pm

Thanks for the quick response Oetker. I wish I had gone down the universal boot route but I have bought the 'proper' boots which are attached to new metal cans. I cut the old cans to get at the shaft and bearings so I have no option other than fitting the new boots and cans.

Should I get the big hammer out?

Title: Re: Driveshaft bearing carrier
Post by: Jon Weywadt on August 31, 2015, 04:09:38 pm

Quote from: Rayburn on August 31, 2015, 12:45:06 pm

Thanks

Hi Rayburn.
Can you please modify your post by deleting the photo and reinsert it after reducing its size.  ;)

Title: Re: Driveshaft bearing carrier
Post by: Oetker on August 31, 2015, 06:27:56 pm

Looks straight forwards, did put on new axles complete 2 years back and still need to revive the old ones .
Make sure to put the tripods  back at the same spot (mark tooth to tripod holder)
The tripods have a  predefined angle to the tripod at the other end  of the  axle.

Good luck