Title: Tightening torque - suspension bridge?
Post by: njesper on November 01, 2009, 04:00:57 pm
Dear fellow matra-dudes,
I am curious to know, how much torque (nm), the bolts have to be tightened, when speaking of the four bolts, holding the suspension bridge to the chassis? :-[
(http://www.natkat.dk/matramurena/assets/bridgenm.jpg)
My murena manual, says nothing of this, and I can see the nuts (with the small housing around them), are the same on the bagheera, so if anybody can come up with this info, I would be very happy. Also if anybody have extra nuts like the ones shown in the picture, please reply. ;D
Best regards,
Jesper
Denmark
I am curious to know, how much torque (nm), the bolts have to be tightened, when speaking of the four bolts, holding the suspension bridge to the chassis? :-[
(http://www.natkat.dk/matramurena/assets/bridgenm.jpg)
My murena manual, says nothing of this, and I can see the nuts (with the small housing around them), are the same on the bagheera, so if anybody can come up with this info, I would be very happy. Also if anybody have extra nuts like the ones shown in the picture, please reply. ;D
Best regards,
Jesper
Denmark
Title: Re: Tightening torque - suspension bridge?
Post by: joe on November 02, 2009, 06:44:00 pm
hello
murena's are biggers than bagheera's
on bagh, torque is 5 mkg
murena's are biggers than bagheera's
on bagh, torque is 5 mkg
Title: Re: Tightening torque - suspension bridge?
Post by: Spyros on November 02, 2009, 07:09:45 pm
hello
murena's are biggers than bagheera's
on bagh, torque is 5 mkg
murena's are biggers than bagheera's
on bagh, torque is 5 mkg
Mais qu'est-ce qu'tu fais ici, toi ? :D
