Title: Accountants ! Post by: Lennart Sorth on May 21, 2006, 06:10:15 pm It annoys me when I find solutions on my car which obviously were selected because they were cheaper. The poor wire quality of the Murena comes to mind, but now I've found a yet another similar stupidity on the Espace.
I just fitted new OZ alloys, and they look cool - except when I came home yesterday evening, and discovered the lefthand front was dirty on the inside... yes, probably a gaiter had gone, as I have seen numerous times on my Murena. The Espace is a 2002 model, so I though it was a bit early. And it *wasn't* the gaiter either, - it was the hose-clamp holding it onto the CV joint ... the hoseclamp is simply a band, which is "micro-riveted" in place. Probably a nice, fast and before all - CHEAP solution :-( With the word of Roy Gillard: "Accountants!" :-) I have attached a picture, and a scale, so you can see the 5 small goosebump-sized humps, which makes it out for "rivets". I suggest JE owners (and others?) go check their hose-clamps. PS: dammn, I got dirty cleaning that mess off - but the alloys are shining again now, so I can see if my emergency fix (using ordinary strips) lasts - while I find a better solution. /Lennart [attachment deleted by admin] Title: Re: Accountants ! Post by: Anders Dinsen on May 21, 2006, 07:57:23 pm Oups, this is a serious problem. You should have the gaiter fixed and bearings greased properly as soon as possible or the bearings will wear out quickly, and a new drive shaft is quite expensive (and needed - as far as I know, they are not restorable.)
Thank you very much for the hint and illustrative picture! Title: Re: Accountants ! Post by: Lennart Sorth on May 21, 2006, 09:06:16 pm You should have the gaiter fixed and bearings greased properly heh - being a Murena owner, I have the Elf CV molybdene grease (MoS2) at hand! so I gave it a good handfull before fixing it temporarily with strips. Will have to find a real hose-clamp though. /Lennart Title: Re: Accountants ! Post by: Anders Dinsen on May 21, 2006, 09:47:07 pm Be prepared! :)
|