Title: Gear Linkage help please!
Post by: TimS on June 05, 2014, 06:28:10 pm
In an attempt to improve my gearchange I took the gear lever and top hat washer off to examine them for wear. Put it all back together and now I can't always get 5th or reverse.
I wonder if i turned the gear lever around 180 degrees by accident when i put it back, but I'm usually pretty careful.
The drawing that I used for reference was not much help. Can anyone show in what order the washer, nut and base should go together?
These are all the photos I took - it wasn't the best light:
https://www.dropbox.com/sh/wqekop3viwn0wfs/AAD2xloibEso8mPn3VrT1J0Ia (https://www.dropbox.com/sh/wqekop3viwn0wfs/AAD2xloibEso8mPn3VrT1J0Ia)
I need to get it working again and then go back to trying to reduce the play in it.
I wonder if i turned the gear lever around 180 degrees by accident when i put it back, but I'm usually pretty careful.
The drawing that I used for reference was not much help. Can anyone show in what order the washer, nut and base should go together?
These are all the photos I took - it wasn't the best light:
https://www.dropbox.com/sh/wqekop3viwn0wfs/AAD2xloibEso8mPn3VrT1J0Ia (https://www.dropbox.com/sh/wqekop3viwn0wfs/AAD2xloibEso8mPn3VrT1J0Ia)
I need to get it working again and then go back to trying to reduce the play in it.
Title: Re: Gear Linkage help please!
Post by: Jon Weywadt on June 05, 2014, 08:54:14 pm
On my Murena there is a detent to prevent you from accidentaly going into reverse. If you turn the shifter 180 degrees that may be the problem. Will look for photos.
