Title: murena 2.2 cylinderhead dowel pins Post by: krede on July 31, 2015, 04:23:19 pm Does anybody know where to get hold of a set of these ? Mine has been lost when I had the cylinder head done :(
Title: Re: murena 2.2 cylinderhead dowel pins Post by: Jon Weywadt on July 31, 2015, 05:06:01 pm Does anybody know where to get hold of a set of these ? Mine has been lost when I had the cylinder head done :( I worried about those myself because one stuck in the head and the others remained in the block. I managed to remove it from the head an set it in the block, where they remained safe. But to your question, I would measure the holes and look for a steel pipe with the correct diameter and a 1/8" wall thickness. As I recall they are appx. 2 cm long. Edges slightly beveled. If hou have a lathe make your own. Title: Re: murena 2.2 cylinderhead dowel pins Post by: krede on July 31, 2015, 05:09:27 pm Yes . I will probably end up making them myself.
|