Title: Driveshaft bearing carrier Post by: Rayburn on August 31, 2015, 01:45:06 pm Refurbishment of my 1.6 has progressed to the back of the car. I need to separate a bearing carrier from its driveshaft to replace the cv boots. I was expecting to see a circlip holding it on but this is what I have found (see attachment) Is there a trick to getting bearing carrier off the shaft?
Thanks Title: Re: Driveshaft bearing carrier Post by: Oetker on August 31, 2015, 02:09:37 pm You don't have to seperate the axle for it if you use universal boots.
(http://a.imageshack.us/img830/5818/p1020595medium.jpg) (http://a.imageshack.us/img837/924/p1020597medium.jpg) (http://a.imageshack.us/img42/7780/p1020600medium.jpg) You can also use a Cola bottle for it or a cone. (http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090401_zps43e6810d.jpg) (http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090423_zps53e36556.jpg) (http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090427_zps5d800710.jpg) (http://i1139.photobucket.com/albums/n544/wobbe98/div/P9090429_zps17f7f959.jpg) Last 4 pics Bart Maztra. Make sure to find the better quality boot. The cheap Chinese sh*t don't last long. Also put the boots before mounting in warm water to soften it. Title: Re: Driveshaft bearing carrier Post by: Rayburn on August 31, 2015, 03:19:11 pm Thanks for the quick response Oetker. I wish I had gone down the universal boot route but I have bought the 'proper' boots which are attached to new metal cans. I cut the old cans to get at the shaft and bearings so I have no option other than fitting the new boots and cans.
Should I get the big hammer out? Title: Re: Driveshaft bearing carrier Post by: Jon Weywadt on August 31, 2015, 05:09:38 pm Thanks Can you please modify your post by deleting the photo and reinsert it after reducing its size. ;) Title: Re: Driveshaft bearing carrier Post by: Oetker on August 31, 2015, 07:27:56 pm Looks straight forwards, did put on new axles complete 2 years back and still need to revive the old ones .
Make sure to put the tripods back at the same spot (mark tooth to tripod holder) The tripods have a predefined angle to the tripod at the other end of the axle. Good luck |