Title: conversion to gti 1.9 (XU9JA) Post by: efijy on September 02, 2015, 11:10:46 pm Hello,
I'm new to matra and planning to rebuild Murena 1.6 I have done some research and know that Peugeot gti 1.9 8v engine fits Murena I have question about axels and muffler: Does Peugeot axels fit to Murena or Murena axels fit to Peugeot engine? (don't want to cut and weld axels) Does Murena muffler fit to Peugeot engine? (don't want to cut and weld muffler) Regards Title: Re: conversion to gti 1.9 (XU9JA) Post by: Oetker on September 03, 2015, 08:15:32 am All you don't want is needed.
Look at the pictures how Bart did it. http://www.maztra.nl/C1900_inb_1.html Later he build in the Mazda engine because he was not happy with the gti conversion. Title: Re: conversion to gti 1.9 (XU9JA) Post by: Oetker on September 03, 2015, 09:24:21 am Maybe to find more info here.
http://www.matrasport.dk/Cars/Murena/Conv/index.html Title: Re: conversion to gti 1.9 (XU9JA) Post by: efijy on September 03, 2015, 03:46:18 pm Thank you for the answer
Maybe i consider rebuilding 1.6 Title: Re: conversion to gti 1.9 (XU9JA) Post by: Bart_Maztra on September 12, 2015, 01:04:22 pm Engine conversion in general:
Figure out best position of engine. (very important) Petroltank might be in the way, so cut or relocate Use original engine chassis mounts :), or get the grinder/welder? :'( Make engine mounts make drive shafts make exhaust manifold adapt cooling hoses/pipes (also for interior heating) adapt excisting electrics. (starter motor, oil pressure light, alternator, reverse light, ignition, etc.) adapt ECU wiring adapt clutch operation adapt gear linkage The GTI engine is a lovely engine. But it is a lot of work to do a proper conversion. It is not a case of bolting a different engine in. Actualy, if the new engine is bolted in, you have only 5% done. The other 95% are all thing stated above. Several murena's are lost because people start with a conversion, and stranded. Title: Re: conversion to gti 1.9 (XU9JA) Post by: efijy on September 12, 2015, 07:54:45 pm This car has sayed outside for 20 years.
Tomorrow i'll bring it to my garage. We will see what happens ;D Title: Re: conversion to gti 1.9 (XU9JA) Post by: Bart_Maztra on September 13, 2015, 08:13:50 pm Custom stainless manifold for GTI engine in murena. Connect to standard 2.2 exhaust. Made myself ;D
(http://i3.photobucket.com/albums/y96/matramurena/DSCF0028-960.jpg) (http://i3.photobucket.com/albums/y96/matramurena/DSCF0031-960.jpg) (http://i3.photobucket.com/albums/y96/matramurena/DSCF0009-960.jpg) |