Title: Alloys for a Bagheera Post by: Nick Gillott on December 24, 2004, 05:54:44 pm Anyone have any preference on alloys / suppliers / manufacturers for alloys? I have the originals (shod with 165 at the front and 185 at the rear) but may go for something prettier downstream.
Is there a modern equivalent car whose alloys go straight on? Title: Re:Alloys for a Bagheera Post by: alimorg on September 21, 2005, 03:52:03 pm Well going by stud pattern, which I believe to be 4x98 you could try most alfas and fiats, if you are prepared to 'oval' the holes a bit with a file the 4x100s from a ford may fit. You would have to find out the corrrect offset though, I tried fitting the alloys from an Audi A3 to a golf once - the calipers fouled the wheels which is odd as they are basically the same car!
Title: Re:Alloys for a Bagheera Post by: Matra_Hans on September 23, 2005, 02:00:19 pm I have seen a Murena with VW Golf rims which according the owner was a direct bolt on. The bolt spacing is 100 mm instead of the 98 mm, but you just need some special bolts with a lose cone that can move a few mm side wards (do NOT make the bolt holes in the rim a bit oval as suggested).
regards Hans |