MatraSport Forum

Each model => Murena => Topic started by: Waldo on May 22, 2008, 09:44:39 pm



Title: Disassembling the driveshafts?
Post by: Waldo on May 22, 2008, 09:44:39 pm
Hmm... I got a question for all you Matra experts!

I need to take the driveshaft assembly apart one way or the other, and now my best bet is to use a grinder  :o

I have the right hand drive shaft in the vice and have tried to seperate the to shafts at the middle joint.
It looks as if the rim of the housing have been rolled to lock the joint in place and also fix the rubber containing grease (gummi-manchet in danish).
If this is true I seen no easy way to take it apart, and it's not even possible to change the rubber seal?

Am I wrong?
Would you have to replace/exchange the driveshaft if the rubber seal is damaged?

Sorry about the bad explanation, but it's rather hard to explain in text  :'(


Title: Re: Disassembling the driveshafts?
Post by: Bart_Maztra on May 24, 2008, 09:09:01 pm
One picture says more than thousend words

(http://i3.photobucket.com/albums/y96/matramurena/asasasas.jpg)

The metal can slides over the outer joint and the edge of the can is rolled in to lock the can. You haveslide the can of the outer joint to separate the joint and to change the gaiter. The gaiter is hold in place by an extra piece of metal in the can.

Before you can slide of the can, you must "unroll" the edge of the can. Or carefully grind around the can.


Title: Re: Disassembling the driveshafts?
Post by: Waldo on May 25, 2008, 12:11:17 pm
Thanks a lot Bart,

That was as I expected...
Though I believe this is an example of rather stupid french design work!


Title: Re: Disassembling the driveshafts?
Post by: krede on June 25, 2008, 06:44:46 pm
Where do one get some replacement joints?.. I can't find them in Simon's catalogue