The scheduled rolling road session in April didn't work out, and then I found out that the rear shocks were gone, so I had to postpone it until they came back from refurbishment, but yesterday the 24th of June, it finally happened: I had the car on the rolling road with F. T. Tuning in Svedala near Malmö:
http://www.ft-tuning.se/We spent about two hours mapping it, trying different jets, both in the idle (low speed) circuit, and the main circuit. It was too rich when we started, much better when we finished, but unfortunately we didn't have a small enough main jet to make it work perfectly, so this is only an intermediate result:
This cam should go far beyond 5000 rpm for max power, so the result of 130 hp on the top is not final at all. The max torque at 3300 is 198 Nm, and that is quite okay and 5% more than an S-cam is spec'ed at.
The jetting we have arrived at so far is
Mains: 140 (too large!)
Airs: 200
Emulsion tube: F9
Idle: 50F9
Ignition was advanced well beyond the 12 degree mark on the clutch housing.
Next step is to buy a set of new jets and do another session.
/Anders