Head gasket wanted please!

[joejusmom]

I have a 1974 Matra Bagheera series 1. 1294cc engine. I am looking for a head gasket as my car is leaking fluid into the cylinder.

If you can help, please contact me docmirror@yahoo.com

[Spyros]

Not difficult to find. If you had said where you are located we woul d be able to help. I have a lot of them in stock

[joejusmom]

I am in Aledo, Texas, USA. Believe me, they are difficult to find in the colonies!

[Spyros]

I sent you an email Joe 

[joejusmom]

Thanks Spyros. got your email, and some good references. Still no luck on the head gasket unless I buy from Simon. a bit pricey with hsipping from EU.

[Spyros]

I'll have a look on how many 1290 cc head gaskets I've in stock. Might be that most of them are 1440 cc. Otherwhise, Frank Mellman in Lubeck is less expensive

[lewisman]

I am pretty sure that the gasket for a 1.3 Peugeot 309 with the OHV Simca engine (1294) will fit and and as they were made from '85 to '93 (I think) so parts are easier to source.

[lewisman]

https://secure.gsfcarparts.com/shop/basket.asp

Try these guys.  They might ship to you.

[joejusmom]

I've sent them an email. They have a listing of N11446 for the head gasket set for Pugeot 309 1.1, 1.3 Talbot engine. Maybe that right, we'll see.

Thanks,

[lewisman]

Hi Joe
Did you manage to lay yourhands on a head gasket?

I was rummaging through some old bits and pieces in my loft looking for some Rancho parts when I came across a brand new head gasket for a Bagheera still in its wrapper.  It lists the 1442 and the 1294 engine.

If you still need one let me know.

All the best for 2008.

David

[joejusmom]

David, just found your post. I still need one. Please let me know about shipping and price. I will take yours, and thanks for keeping me on the road. Email sent also.

[joejusmom]

David was kind enough to send me a head gasket. I owe him something for it. Just arrived a few days ago.

But, I made a huge mistake and let my 17 year old son drive the car. I've been gentle on the clutch, but he burned it up in about 10 minutes. Sigh, never ends. I'll be looking for a clutch disk, pressure plate, and release bearing now. I think I better contact MatraMagic.

Once again, if anyone has sources for these parts, I would be grateful. In the US, we have no source for any Matra parts.

Thanks David, let me know what I owe you for the gasket.

[lewisman]

No worries.

pm sent

Let me know if you need help sourcing a clutch.

David

[joejusmom]

Oh yes, I need help. I've got the plan to get the car apart next month before it gets murderously hot here in Texas. I've asked around about rebuilding and the plate is no problem, but no one will try the pressure plate. That's the sticker.

Let me know price and availability, and I'll send you some Pounds, or Euros, or whatever.

Thanks,

Doc

[lewisman]

Can you please measure the outside diameter of the clutch plate. 

Alternatively, does anyone else know the equivalent part number for a Valeo or Borg & Beck clutch kit?