Title: Developping a new Bagheera Bonnet pannel II Post by: Spyros on August 24, 2008, 12:37:16 pm So, after creating a new mold, I apparently forgot to take pictures.
During a long period, my manufacturing projects where left dormant. This because I was focusing on the redaction of the Last Matra Bagheera Manual ( a manual covering years 1978 to end, which was never published by Matra. About 400 pages, own published, already 60 % of printed copies sold) End of July, the status was the following : (http://img108.mytextgraphics.com/photolava/2008/08/26/img9286b-4bngb20u1.jpeg) My planning was to be ready by mid august. It would have been the case if the project would have been to reproduce a steel panel in fiberglass. But ... I revised the scope of the project. This because an important assumption was not correct : The pannel needs to glue perfectly to the external polyester panel in order to maintain structural rigidity.µ As I will show you, this is not true with the original steel panel and would cause an issue if the steel is replaced by polyester |