MatraSport Forum

Each model => Murena => Topic started by: njesper on November 01, 2009, 04:00:57 pm

Title: Tightening torque - suspension bridge?
Post by: njesper on November 01, 2009, 04:00:57 pm

Dear fellow matra-dudes,

I am curious to know, how much torque (nm), the bolts have to be tightened, when speaking of the four bolts, holding the suspension bridge to the chassis?  :-[

(http://www.natkat.dk/matramurena/assets/bridgenm.jpg)

My murena manual, says nothing of this, and I can see the nuts (with the small housing around them), are the same on the bagheera, so if anybody can come up with this info, I would be very happy. Also if anybody have extra nuts like the ones shown in the picture, please reply.  ;D

Best regards,

Jesper
Denmark

Title: Re: Tightening torque - suspension bridge?
Post by: joe on November 02, 2009, 06:44:00 pm

hello
murena's are biggers than bagheera's
on bagh, torque is 5 mkg

Title: Re: Tightening torque - suspension bridge?
Post by: Spyros on November 02, 2009, 07:09:45 pm

Quote from: joe on November 02, 2009, 06:44:00 pm

hello
murena's are biggers than bagheera's
on bagh, torque is 5 mkg

Mais qu'est-ce qu'tu fais ici, toi ?  :D