Best tyres to buy in original dimension?

[Mattias Henriksson]

Thanks for your advise and I agree a Murena should have more classic type of wheels. I found a set of Aluline wheels that need sandplasting and some paint, see attached photo with the same type.
Dim 7x15 and ET 13 but the bolt pattern is 100x4, think it can be solved with special bolts to compensate for the 2 mm differance. Centrum hole is 57,1mm so it needs some machining up to 58,1 but that can be solved. Will use tyres with dim 195/205 in 50-profile.

[GP]

Oooh they are nice! 

[Oetker]

Murena has ET29.
Ithink ET  13 wil do but not sure.
50 height front wil be OK.

I have 45 front and 55 rear and 7J ET25
It has good dirve abillity because the car is more wedge.

Wheel look good.

[GP]

That's very interesting as I did not know that special bolts / "Wobble Bolts" even existed!

https://www.team-bhp.com/forum/tyre-alloy-wheel-section/168043-pcd-variation-bolts-aka-wobble-bolts-myth-versus-reality.html

[matramurena]

Those are some nice rims! Wil look nice and wide as well with an ET of 13! Wobble bolts work very well, just make sure you buy a decent set and that the centre-hole fits snug with your hub.

[Mattias Henriksson]

Also found these new wheels from Japan racing during my search on internet...
Have an nice style with a classic touch with the cross spoke pattern that I think would fit the Murena. Available in 4x98 with centrum hole 58,1 in dim 8x15, ET20.
Will be the same money as for the Aluline that I bought with machining, sandblasting, powdercoating and new bolts...so I have to think about it!

// Mattias

[GP]

These are my posh "going out" wheels! 

[Mattias Henriksson]

Very nice wheels!! Dimensions?

[GP]

Application: Delta Integrale 16v Only
Size: 7" x 15"
Offset: ET27
PCD: 4 x 98
Centre Bore: Matra Murena

Tyres Front: 195/50VR15
Tyres Rear: 205/50VR15