Throttle position plug

[RobB]

Hi, I m at the point of fitting lpg conversion to my 94 espace. One of the wires from the electonics has to connect to the c terminal of the throttle position sensor. I had a quick fiddle this afternoon but could not remove the connecting plug. I presume that it pulls off after pressing the two small plastic lugs on either side of the plug but I could not remove the plug. I thought that I would check here before I carry on in case I have it wrong and saw this post. So is the plug just a tight fit and I have to pull harder and do the small lugs have to be depressed first . thanks Rob

[Anders Dinsen]

I have split your question into a seperate thread as it did not make relevance with the one you placed it in

These plugs are the standard Bosch plugs and they are designed to be difficult to remove, but as long as you don't pull the wire, you will not risk breaking anything by pulling. There are no tabs to press, but there's a locking wire around the plug which will have to be pulled past the tabs on the connector on the TPS.

I suggest you fiddle some more

- Anders

[RobB]

Thanks Anders. Easy when you know how!
Rob