Murena 2.2 cylinder head bolts torque settings?

[macaroni]

Can anyone tell me the torque settings for the cylinder head bolts on the 2.2 please?

Cheers,

Antony

[Anders Dinsen]

90 Nm

[macaroni]

Thank you.

[macaroni]

Can you tell me the valve clearances also please?

[Anders Dinsen]

Can you tell me the valve clearances also please?

No, the manual is back on the shelf again

Okay... here goes:

Inlet: 0.2 mm
Exhaust: 0.3 mm

Cold engine.

[macaroni]

Thanks again.

Can you also please tell...just joking.

Cheers,

Antony

[Anders Dinsen]

Can you also please tell...just joking.

No, I don't know any jokes!

You're always welcome

[krede]

remember to "pre torque"  all the bolts 5nm, before you go on to fasten them 90 nm.

Also there is a specific sequence you need to torque up the bolts in.

[macaroni]

I just wanted to check them. I did it from the middle, working outwards. They were all tight enough.
I'm going to check the valve clearances next, once it stops raining!

[roy4matra]

Can anyone tell me the torque settings for the cylinder head bolts on the 2.2 please?

All the engine torque settings are available from my website if you just asked me.  There is a double A4 page taken from the workshop manual.  Valve clearances are in the Murena handbook.

Roy

[macaroni]

I looked, but couldn't find them on there and still can't.

Can you point me at them please?

[roy4matra]

I looked, but couldn't find them on there and still can't.

Can you point me at them please?

No you won't.  I said 'if you ask'.  If anyone emails me I can send them a link.

Roy

[Anders Dinsen]

I just wanted to check them. I did it from the middle, working outwards. They were all tight enough.
I'm going to check the valve clearances next, once it stops raining!

Weather over here is beautiful
Did you get a chance to identify your cam then?

- Anders

[macaroni]

Only just stopped raining now!
My car is garaged, but I want it dry so I can roll it in and out in 4th gear to rotate the valvetrain.

I looked at my cam, but couldn't identify it. I'll photo it tomorrow, in the light, and post it up.

[roy4matra]

Can you tell me the valve clearances also please?

Inlet: 0.2 mm
Exhaust: 0.3 mm

Cold engine.

However, that is for the standard cam, Anders.

The Holbay cam has slightly different settings.

The inlets should be: 0.25 mm (10 thou)
Exhausts as original: 0.30 mm (12 thou)

Roy