Glue for murena body panels

[klumzer]

Waterproof!!!!

http://marinemechanic.com/site/page207.html
[/quote]

I used similar rives at the back of the spotlight housing.

[klumzer]

Countersunk aluminium 3.2mm dia. x 10mm length and use a backing washer inside. Panel holes 3.2mm and chassis holes 4mm for a bit of extra tolerance.

GP
[/quote]

Thanks GP. I bought the same size. But the holes on the chassis are also about 3.2mm on my car... no problem, because after repair works we have to drill and countersunk the holes again on the roof panel so probably it will fit perfectly.

B.T.W. When can we see some photos of your new 'Aston Martin'? 

[GP]

Oh O.K. then here a a few top secret sneak preview shots then

Note the paint sparkle on the petrol filler cap shot in particular!  

GP

[klumzer]

Thanks. Very nice!

[klumzer]

Hi GP,

I did not want to off your other topic so I put my question here.
Did you have any difficulty with the body panel installation? You mentioned that you used large headed bolts and rubber nut inserts...