Steering knuckle

[Drbagheera]

Hi
Having real trouble removing the bottom ball joints on my 2.2 project. Anyone have an old pair of knuckles/ hub i could use and try to change the balljoints on? I seriously doubt anything i find could be as as rusty as the ones I have!
Cheers
Ian

[GP]

Can you post a picture of your requirements?

[Drbagheera]

This is from the bagheera - but looks the same to me.
It is the circled upright which houses the wheel bearing, connects the steering/torsion bar and shocker. It houses the bottom balljoint too which is a screw fitting. I do not know if the 1.6 differs from the 2.2 but I would doubt that if only on efficiency grounds.
Thanks

[GP]

What about these two?

Wheel bearings are seized but lower balljoints are actually O.K.

[Oetker]

I think there are differences om the items showed from the bagheera.
The lower ball-joints are smaller and dust-plates and cylinders  are not the same as far as  I know.
The 1.6 and 2.2 Murena have the same front/
Only numbers for the frontshocks are different.
Torsion bars and stab bar are thicker.

Herman

[GP]

Haynes (or Similar) Simca 1100 Manual covers the front suspension nicely, torques etc...

http://www.ebay.co.uk/itm/Simca-1100-1204-Special-Ti-1967-79-Workshop-Haynes-Manual-Mint-Condition-/390901730164?pt=UK_CarParts_Vehicles_Manuals_Litterature_ET&hash=item5b038f0b74

[Drbagheera]

Thanks for offer on the parts. As i have now managed to undo one, i'll see how the other goes now. Cheers