| Home  Blogs Help Search Login Register  
« previous next »
Pages: [1] Print
Author Topic: Developping a new Bagheera Bonnet pannel IV  (Read 2141 times)
Spyros
Moderator
Sr. Member
*****
Posts: 323

I'm a real donkey!


WWW
« on: August 31, 2008, 10:42:12 am »

So, when all the panel has been glued with the new dimension, I can unfix it from the outside skin I used.

Turn it upside down and start filling the gap.

For this I use fiber reinforced filler.



Actually, even if this filler is mandatory, it will generate some issues.

First it is very hard to grind down.
Also, this will generate irritating fiber powder.

In order to produce the mold, I'm using various types of fibers.



1) Very light vowen fiber. Not a lot of strenght but will adapt itself without difficulty to any type of curves.
This is a must as first coat (after the gel coat)
Price : About 8 euro for a square meter

2) Matt. Very good, powder impregnated so that it will drink the resin. Not as flexible as the first tissue but will still follow the curves reasonably well. 300 (exist aslo in 450 or higher)
Price : About 2 euro per square meter.
Use a couple of coats

3) Old Matt. Don't remember where it came from. Doesn't follow the curves. Good to arm yourself. Don't use this !

4) Very dense vowen tissue. Difficult to impregnate but will provide a lot of strenght 

Now the mold is about done.



But I got too much allergia from this powder and I'll stop for a week.
Logged
Anders Dinsen
Administrator
YaBB God
*****
Posts: 2822



WWW
« Reply #1 on: September 02, 2008, 02:42:08 pm »

Great work, Spyros. Hope you will recover from the dust-exposure!  Smiley
Logged

'82 Murena 2.2 prep 142
'01 Grand Espace 24v
'08 Smart Fortwo 0,8 cdi
Pages: [1] Print 
« previous next »
Jump to: