|
|
|
|
GP
Sr. Member
Posts: 302
|
|
« Reply #4 on: December 23, 2014, 03:33:38 pm » |
|
|
|
« Last Edit: December 23, 2014, 03:35:56 pm by GP »
|
Logged
|
|
|
|
|
GP
Sr. Member
Posts: 302
|
|
« Reply #6 on: December 23, 2014, 06:21:16 pm » |
|
Ahh, interesting tool. Is this the right size for a matra? I have managed to undo the ns balljoint now after lots of hammering and some grinding. Thanks for the help Ian
Yes this is the right Matra specific tool. 1/2" sq Drive ID 49 mm - OD 58mm Do follow the instructions closely by clamping the tool on with the existing nut otherwise the prongs will bend: The procedure for the use of this socket is outlined below: Remove the nut from the ball joint, fit socket over the joint locating lugs into the recesses. Replace the nut and tighten to lock the tool onto the joint. Unscrew the ball joint using a socket or spanner on the remover. Fit the replacement by reversing the procedure.
|
|
« Last Edit: December 23, 2014, 06:34:24 pm by GP »
|
Logged
|
|
|
|
|
|
|
|
|
|
|
|